Inorganic pre coated board, also known as clean board, has fire resistance, aging resistance, and water resistance, while maintaining a bright appearance and giving people a clean feeling. This board is widely used in various fields of interior and exterior walls such as subways, tunnels, sports venues, laundry rooms, and office buildings. Before installing inorganic pre coated panels, try to preserve the original packaging as much as possible and store it indoors. If it needs to be stacked outdoors, the stacking location should be flat, without standing water, and there should be no lifting equipment or heavy objects passing through. Under the board, wooden pads should be used to elevate it by 20 centimeters, and soft materials should be placed between the boards. Boards of the same model should be placed together and labeled with easily recognizable board type tags on each stack, and covered with rainproof oilcloth. Temporary enclosures should be set up in the stacking area to prevent unnecessary damage to inorganic pre coated boards caused by personnel walking.

The installation of inorganic pre coated boards in Pailun usually uses movable scaffolding, which needs to consider the bearing capacity of the construction scaffolding and pay attention to the following points: the distance between the wall, curtain wall, work surface and axis; Identify the spacing, position, and visibility of control points; Find the spacing between installation angles; The horizontal difference between the control elevation; The vertical distance from the building and the distance from each floor. When transporting inorganic pre coated boards, both ends should be lifted simultaneously to avoid damaging the surface oxide film or coating. When installing wall panels, only one panel can be lifted at a time. The fixtures provided by the manufacturer should be used, and two lifting points should be used at the joint of the wall panel length direction. During the lifting process, it should be carried out slowly and controlled with wind ropes to avoid collision with the installed wall panels. The protruding parts of the scaffold should be wrapped with soft materials.